3.Loosen each bearing setscrew and slide bearings inward, away from horizontal end supports.
1 | 5 |
|
IMPORTANT: Brush gearbox splined shaft will separate from brush housing
2 |
3 |
2
4
4 |
1 |
1. Brush Segment |
2. |
3. Splined Shaft |
4. Gearbox |
Figure 19 |
4.Manually move traction unit backwards, pulling brush housing away from brush assembly.
NOTE: The gearbox at the center of the brush allows only half the brush segments to be removed from each end.
5.Stand brush assembly upright on one end.
6.Remove three flanged bolts securing end plate to support shaft assembly. Remove the end plate (Figure 20).
3
1.Flanged Bolts
2.Engagement Fingers
3.Support Shaft Assembly
4.Brush Segment
5.End Plate
Figure 20
EN - 26
