ASSEMBLY
WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.
Tools Required:
•Tire Gauge
•Pliers
•
Unpacking Unit
WARNING: Dropping or tipping over boxed unit could result in personal injury or damage to unit.
Unfold Handlebar
(Figure 3)
1.Remove the lower and loosen the upper hardware on the handlebar assembly.
2.Loosen the hardware on the shift rod.
3.Put the speed selector lever in the second reverse position.
4.Rotate the handlebars into operating position.
IMPORTANT: Be careful not to damage cable spring hooks when rotating handlebars upward.
5.Install and tighten all hardware on the handlebar assembly and shift rod.
4 |
3 |
1 |
2 |
1. Handlebar Hardware |
2. Shift Rod Hardware |
3. Shift Rod |
4. Speed Selector Lever |
Figure 3 |
Check Function of Dual Handle Interlock
Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction clutch lever is released, then both clutches must disengage. If they do not, contact your Dealer for repairs.
EN - 8
