Check Tire Pressure
Check tire pressure and adjust to the pressure listed on tire sidewall.
CAUTION: Avoid injury! Explosive separation of tire and rim parts is possible when they are serviced incorrectly:
•Do not attempt to mount a tire without the proper equipment and experience to perform the job.
•Do not inflate the tires above the recommended pressure.
•Do not weld or heat a wheel and tire assembly. Heat can cause an increase in air pressure resulting in an explosion. Welding can structurally weaken or deform the wheel.
•Do not stand in front or over the tire assembly when inflating. Use a
Check Engine Crankcase Oil
IMPORTANT: Engine is shipped with
Fill Engine Fuel Tank
Refer to Engine Manual for proper fuel type and tank capacity. Refer to FILLING FUEL TANK on page 13.
Check Function of all Controls
Ensure unit runs and performs properly. Refer to Operation on page 11.
Run-in Attachment Belt
1.Start unit in a
2.Engage attachment clutch lever and run attachment for about 15 minutes.
3.Stop unit, wait for all moving parts to stop, and remove spark plug wire.
4.Adjust clutch idler according to Attachment Clutch Adjustment on page 21.
5.Adjust belt finger, if necessary. See Check Belt Finger Clearance on page 22.
EN - 9
