ASSEMBLY

WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.

WARNING: Dropping or tipping over boxed unit could result in personal injury or damage to unit.

5.Install and tighten all wing knobs and wing nuts on the handlebar assembly and shift rod.

NOTE: The handlebar has two height positions. Adjust the handlebar height to provide better operator comfort. See Handlebar Height on page 27.

PACKAGE CONTENTS

4 1

5

4

1

3

 

 

2

OS7020

 

1.

Sno-Thro

4. Literature

 

Unit

Pack with

2.

Discharge

Extra Shear

 

Chute

Bolts

3.

Chute Rod

 

Figure 3

ASSEMBLY

Tools Required:

•Pliers

•Open-End Wrenches: 3/8, 7/16, 1/2, 9/16 in. and/or Adjustable Wrench

•Tire Gauge

Unfold Handlebar (Figure 4)

1.Remove the lower and loosen the upper wing knobs on the handlebar assembly.

2.Loosen the wing nuts on the shift rod.

3.Put the speed selector lever in the first forward position.

4.Rotate the handlebars into operating position.

1, 3

2, 3

OS7030

 

 

1.

Wing Knobs

4.

Shift Rod

2.

Wing Nut

5.

Speed

3.

Bolt

 

Selector

 

 

 

Lever

Figure 4

Install Discharge Chute and

Discharge Chute Crank

(Figure 5)

1.Grease underside of discharge chute ring (if not already greased).

2.Remove mounting hardware from auger housing.

3.Install discharge chute over opening in the auger housing. Finger tighten the mounting hardware removed in step 2.

NOTE: Leave discharge chute pedestal loose to help install the chute rod and connect it to the control assembly.

GB - 10