NOTE: Press down on lock teeth with your finger to align the cable ball end with the slot (Figure 8).

OS7271

Figure 8

10.Replace the gear cover removed in step 4.

IMPORTANT: Rotate the discharge chute to the left when tightening the pedestal hardware to ensure clearance between the discharge chute and the belt cover.

11.Tighten pedestal hardware to 15 – 31 lbf-ft (20 – 42 N•m).

12.Make sure the discharge chute rotates left and right when you push the discharge chute control lever left and right.

Deflector Remote

(Figure 9)

Connect the cable end to the cable anchor on the discharge deflector before clipping the cable to the cable bracket on the discharge chute.

1.Route deflector remote cable along the left side of the chute pedestal.

2.Insert the barrel on the cable end into the bracket on left side of chute deflector (Figure 9).

3.Hold seal out of the way while routing the cable through the bracket on the left side of the discharge chute, and then push the cable fitting into the bracket.

4.Push the seal securely over the end of the cable fitting to prevent water from entering the cable.

5.Check deflector travel. Adjust nut on cable end under handlebar to obtain full travel, if necessary.

23

1

3

5

4

1. Cable Anchor

OS7070

 

2.Cable End

3.Deflector Cable

4.Cable Fitting

5.Cable Bracket

Figure 9

Connect Battery (926312, 313, 316)

1.Remove wing nuts from battery cover.

2.Install wire lead to battery terminal.

3.Install battery cover and tighten wing nuts.

Check Function of Dual Handle Interlock

Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction clutch lever is released, then both clutches must disengage. If they do not, contact your Dealer for repairs.

Check Tire Pressure (926302, 310, 311, 312, 313)

Check tire pressure and adjust to the pressure listed on tire sidewall.

GB - 12