7.Check and adjust attachment clutch, speed selector and traction clutch. See Speed Selector Adjustment on page 29 and Traction Drive Clutch Adjustment on page 32.

8.Re-install bottom cover.

2.Loosen adjusting nuts on cable support bracket underneath the dash panel (Figure 28).

3.To adjust the deflector lower:

Slide cable down. Tighten bottom nut.

4.To adjust deflector higher:

REMOTE WHEEL LOCK (926302)

If remote wheel lock does not lock or unlock:

1.Place unit in service position (see Service Position on page 23).

2.Loosen jam nuts on cable. Make sure the bottom jam nut is loosened enough to remove slack from cable (Figure 27).

3.Pull the cable adjuster to remove slack between the cable adjuster and the extension spring and hold the cable adjuster in position while finger tightening the top jam nut against the bracket. Do not extend the spring or engage the mechanism.

4.Tighten the bottom jam nut.

5.Check function of remote wheel lock. If wheel lock does not function properly, remove bottom cover to check cable slack.

6.Repeat steps 2 – 4 while watching cable to remove slack.

7.Check function of remote wheel lock. If wheel lock does not function properly, take the unit to Dealer for repairs.

3

1

No Slack

2

OS7170

 

1.Top Jam Nut

2.Bottom Jam Nut

3.Cable Adjuster

Figure 27

DEFLECTOR REMOTE

Slide cable up. Tighten top nut.

5.Check travel and repeat adjustment as necessary.

OS7175

1

2

1.Adjusting Nuts

2.Cable Support Bracket

Figure 28

DISCHARGE CHUTE

If chute does not stay in position while throwing snow or if chute does not rotate freely, adjust the cable under the control panel so the chute lock fingers engage or disengage the locking gear.

If chute does not stay in position:

Loosen the cable by loosening the lower adjustment nut, and then tightening the upper adjustment nut against the bracket (Figure 29).

Deflector must stay in selected position while throwing snow.

If deflector does not stay in set position:

1.Tighten nut beneath control panel to increase pressure on deflector control (Figure 28).

If deflector does not follow full range of travel:

1.Push deflector remote all the way forward.

GB - 28