12
2
2
2
1. Quick Hitch Adapter | 2. Quick Hitch Stud |
Figure 15
IMPORTANT: Tighten and loosen the bolts in a cross sequence as shown in Figure 16.
|
| 6 |
| 1 | 4 |
|
| |
3 |
| 2 |
|
| |
| 5 |
|
Figure 16
4.Tighten all PTO brake bolts until the springs are solid. Back all bolts up 1/2 turn (Figure 17).
2
1
3
1. PTO Brake Bolts
2. Springs 3. PTO shaft
Figure 17
NOTE: Make sure the trunnion block is on the shipper shaft and held in place by the dog. The dog should rest on the spiral teeth of the clutch dog plate. Install the gas- ket (Figure 18).
Align the splines on the quick hitch shaft with those in the dog. Slide the quick hitch casting and PTO brake assembly back into the place on the front of the transmission. Install the quick hitch studs and tighten.
| 2 |
|
|
1 |
|
|
|
8 |
|
|
|
|
|
| 3 |
|
|
| 4 |
|
|
| 5 |
| 7 |
|
|
|
|
| 6 |
1. | Shifter Parts | 5. | Dog |
2. | Wiring Harness | 6. | PTO Slip Clutch |
3. | Shipper Shaft |
| Assembly |
4. | Trunnion Block | 7. | Clutch Dog Plate |
|
| 8. | Gasket |
|
| Figure 18 |
|
SLIP CLUTCH
WARNING: Stop the engine before adjusting the slip clutch.
To adjust the slip clutch:
1.Remove the attachment and lower the rear of the tractor to the ground.
2.Carefully clean the front of the transmission.
3.Remove the quick hitch studs from the transmission.
4.Remove the quick hitch PTO assembly and PTO brake assembly.
NOTE: The attachment gasket must be replaced if damaged.
5.Remove the dog and trunnion block (Figure 18).
6.Disconnect the wiring harness from the PTO brake interlock switch.
7.Remove the shifter parts.
8.Slide the shipper shaft assembly through the top of the advance casting.
9.Slide the clutch assembly and pinion shaft out of the transmission (Figure 18).
10.Remove the retaining ring and slide the clutch assembly off of the pinion shaft.
GB - 18
