Switching off the electricity
!Turn off the mains switch before cleaning it and during all maintenance operations.
●Before switching on again, ensure that all controls are in the OFF position.
Cleaning the oven doors
Oven door removal (Main Oven)
The door is removable to facilitate occasional cleaning of heavy soiling from the oven floor and from the door itself.
●Please note that the door is heavy and care should be taken not to pinch your fingers during the removal and replacement.
To remove
1.Open the door fully and, using a coin or screwdriver, turn the two discs clockwise.
2.Slightly close the door, unhook the lower hinge fingers, then pull the door away from the oven front frame.
To replace
1.Insert the lower fingers and the hooked ends of the door stays, ensuring that the slots in the lower fingers engage with the front frame.
2.Fully open the door and turn the discs anti- clockwise to their normal working positions. Close the door - the hinge will now lock into position.
● Take particular care not to damage the inner surface | GB | |
of the door inner glass that is coated with a heat | ||
| ||
reflective layer. |
|
!Do not use scouring pads, or abrasive cleaners / powder, which will scratch the glass. Ensure that the glass panel is not subjected to any sharp mechanical blows.
Stubborn stains can be removed by using a fine steel wool pad. For slight soiling the inner glass panel may be cleaned, while still warm, without removing it from the door. After cleaning, rinse and dry with a soft cloth.
Side opening doors
Cleaning the door glass is the same as the drop down doors, except take care to support the weight of the inner glass when removing and refitting.
Drop down doors
Remove the door inner glass as follows:
1.Open the door fully and unscrew the two screws securing the glass panel so that the securing brackets can be turned. There is no need to remove the screws completely.
2.Turn the brackets so that the glass can be removed and cleaned at the sink.
3.The inside of the outer door glass can now be cleaned while still fitted to the cooker.
!Never operate the cooker without the inner door glass in position.
Refit the door inner glass as follows:
1.NOTE: The inner door glass has a special reflective coating on one side. Replace the door inner glass so that the statement: “IMPORTANT THIS FACE TOWARDS THE OVEN” can be read from the inner side of the door.
2.Turn the two securing brackets back to their original position to retain the glass and tighten the screws.
29
