Installation
Caution
Do not block the unit’s heat sink, thus preventing air circulation. If blocked, heat will accumulate inside the unit and may cause a fire.
Heat sink
•The main unit must be mounted within 30 degrees of the horizontal plane, back to front.
Less than 30°
1 Stick the Installation Template to a chosen mounting location, and drill holes according to the Installation Template’s indication.
2 Open the front panel, and install the unit as show below.
| Support Strap | |
| (Included) | |
Mounting location in boat’s |
| |
This unit | Rubber Cap | |
(Included) | ||
Screws (M4X30) | ||
Hex Bolt | ||
(Included) | ||
(Included) | ||
|
iPhone/iPod Connection (sold separately)
Connect USB cable to an iPhone/iPod with Interface cable for iPod.
USB cable
Interface cable for iPod (supplied)
Remove the iPhone/iPod
Remove the iPhone/iPod from Interface cable for iPod.
•Remove the iPhone/iPod after the unit has been changed to a source other than the iPhone/iPod. If the iPhone/iPod is removed while playing, data may be lost.
•If sound is not output or the iPhone/iPod is not recognized even when the iPhone/iPod is connected, remove the iPhone/iPod once, then connect it again, or reset the iPod.
•Do not leave the iPhone/iPod in a boat for a long time. Heat and humidity may damage the iPhone/iPod and you may not be able to play it again.
USB memory Connection (sold separately)
Connect USB memory
Connect the USB cable to the USB connector of the unit, and then secure the connection using the lock case supplied with USB cable as shown below.
This unit | USB memory |
| (sold separately) |
lock case
*1 Ground Lead |
Battery |
USB connector
Remove USB memory
Cable (supplied)
Front Frame |
Reinforce the head unit with the support strap. Secure the ground to a wire attached directly to the boat’s negative battery terminal.
•For the screw marked “*1”, use an appropriate screw for the chosen mounting location.
Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the
3 Close the front panel.
46-EN
Pull out USB memory squarely from the USB cable.
This unit |
|
|
|
|
| USB memory | |||
USB connector | (sold separately) | ||||||||
|
| ||||||||
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
Cable (supplied)
•When removing USB memory, pull it out straight.
•If sound is not output or USB memory is not recognized even when USB memory is connected, remove USB memory once, then connect it again.
•Change to a source other than the USB memory mode, then remove the USB memory. If the USB memory is removed in the USB memory mode, data may be damaged.
•Route the USB cable away from other cables.