Getting Started
TUNER/SOURCE
Rotary encoder (OPEN)
| VOL.ZONE | /ENTER |
| FUNC./SETUP MUTE |
|
Accessory List |
| |
• | Marine CD receiver ............................................................ | 1 |
• | Power cable ........................................................................ | 1 |
• | USB cable ........................................................................... | 1 |
• Interface cable for iPod ..................................................... | 1 | |
• | Rubber Cap ........................................................................ | 1 |
• | Hex Bolt .............................................................................. | 1 |
• | Screw (M4x30).................................................................... | 6 |
• | Support Strap..................................................................... | 1 |
• | Installation Template ......................................................... | 1 |
• | Owner’s Manual .......................................................... | 1 set |
Turning Power On and Off
Press TUNER/SOURCE to turn on the unit.
•The unit can be turned on by pressing any other button except Rotary encoder.
Press and hold TUNER/SOURCE for at least 2 seconds to turn off the unit.
•The first time power is turned on, the volume will start from level 12.
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first time, after changing the boat battery, etc.
1 Turn off the unit power.
2 Slide (OPEN) to open the front panel.
3 Press RESET with a ballpoint pen or similar pointed object.
Multi-Zone Volume Control
Press VOL.ZONE to switch the volume mode, and the appropriate indicator lights up.
ALL
ZONE1
ZONE2
ALL
ALL : All Speaker Volume control (Front, Rear, Subwoofer, ZONE2 Speaker).
ZONE1 : Volume control for 3 Preouts (Front, Rear, Subwoofer).
ZONE2 : Volume control for ZONE2 Speakers only (ZONE2 Speaker).
•When the ZONE1 or ZONE2 is selected, its Volume Level is adjustable, and another Volume Level is fixed.
•If ALL is selected, when the Volume Level for ZONE1 and ZONE2 is different, the Volume Level that reaches to 0/35 cannot be adjustable.
Adjusting Volume
Turn the Rotary encoder until the desired sound is obtained.
Lowering Volume Quickly
Activating the Audio mute function will quickly lower the volume level. The unit has 3 mute modes and 6 mute levels.
Press and hold MUTE for at least 2 seconds to select one of the three MUTE modes.
Press MUTE to activate the selected mode.
ALL
ZONE1
ZONE2
ALL
ALL : ZONE1 and ZONE2 Enter Mute mode.
ZONE1 : Only ZONE1 Enters Mute mode.
ZONE2 : Only ZONE2 Enters Mute mode.
Press MUTE again, and the mute function is canceled.
•For the Mute Level, refer to “Setting the MUTE Level (MUTE LEVEL)” (page 24).
About Auto Save
The adjusting/setting content of items in the table below will remain even when the battery is disconnected.
•The setting content of the items with “*” will be saved in 10 seconds after setting.
Items to be adjusted/set | Reference page |
|
|
|
|
Lowering Volume Quickly* | |
|
|
Adjusting Subwoofer/Bass/Treble/Balance |
|
(Between Left and Right)/Fader (Between Front and | |
Rear)/Loudness/Defeat |
|
|
|
Setting the Bass Control | |
|
|
Setting the Treble Control | |
|
|
Adjusting the High Pass Filter | |
|
|
Search Position Memory | |
|
|
Presetting Stations Manually | |
|
|
SETUP Setting | |
|
|