Arkon Channelmag instruction manual Cable Types

ChannelMag Section 2 Installation

2.6 Cable Types

ChannelMags are connected to a junction box normally using cables in flexible 1” (25mm) conduit. See the ChannelMag Sensor Specification for the standard cable and conduit lengths.

The cables and conduit are stowed for packing against the side of the Magnetic Enhancement Plates and are marked “coils,” “electrodes,” and “reference.” The cables from the junction box to the transmitter are without conduits and connected to the remote transmitter terminals as follows (see separate instructions for the transmitter):

Exciter Coils	Electrodes	Reference Coils
Black to 4	Black to 24	Black to 31
White to 5	White to 25	White to 32
Shield to 6	Shield to 26	Shield to 19

The junction box is submersible and is potted with a re-enterable gel, but is not intended to be installed in the media flowing in the channel. Cables from dual sensors are wired in the junction box as shown below in Section 2.6.2.

19