Armstrong World Industries 6100, 6300, 6500, 6700 - page 20

Figure 20-1 HC-6100/6300

Figure 20-2 HC-6500/6700

4. Inspect tank drain screen and elements inside the tank. The elements should appear to be flaking

off scale. If the drain screen appears to building deposits in the screen holes it should be cleaned.

Remove any scale that appears in the bottom of the tank.

5. Install six (6) new ionic beds (14 for the HC-6500/6700), snapping them into place on the

support pins.

6. Make sure access panel gasket is lapped over all edges of tank access opening. Replace and

secure tank access panel.

7. Make sure both access doors/panels are secure.

8. Turn on power at circuit breaker.

20

Steam Outlet

Equalizing Connection

to Top of Level Canister

Cover

Ionic Beds

Equalizing Connection

to Bottom of Level Canister

Heating

Elements

Drain Oulet

Connection

Locating

Pins

Mounting Bolt

Locations

Cover

Ionic Beds

Heating

Elements

Drain Outlet

Connection

Mounting Bolt

Locations

Locating

Pins

Equalizing Connection

to Bottom of Level Canister

Equalizing Connection

to Top of Canister

Steam Outet

Contents

Main HumidiClean Series HC- 6100/6300/6500/6700 Humidifiers Installation, Operation and Maintenance Instructions Table of Contents Page Page Model Description Pre-Installation Page Installation HC-6100/6300 Mounting HC-6500/6700 Mounting Water Fill Supply Electrical Service Wiring Drainage Figure 7-1 HC-6100/6300/6500/6700 Table 7-4. Steam Capacities and Rating Amperages Table 7-3. Steam Capacities and Rating Amperages Table 7-2. Steam Capacities and Rating Amperages Duct Steam Distribution Area Steam Distribution Alternative for shortened non-wettable vapor trail Control Wiring Page Supply Control Signal Main Stat/Sensor In Modulating High Limit Sensor Outdoor Temperature Sensor Ground Figure 11-1 0-10 Vdc or 4-20mAControl Signal Figure 11-2 RH Sensors/Transmitters Supply Main Stat/Sensor In Modulating High Limit Sensor Outdoor Temperature Sensor Ground High Limit Humidistat Airflow/Pressure Switch Alarm Circuit Display Menu Run Menu Language Unit Status Operation Setup Operation Setup - Continued Start-Up Procedure (Before Power On) Principle of Operation Completing a Service Life Cycle A. Servicing the Unit End of Season Drain Maintenance Replacing the Ionic Beds Page Cleaning the Water Level Electrodes Removing the Tank, HC-6100/6300 Only Troubleshooting Humidifier will not fill with water when power is applied. Page Humidifier overfills with water on initial fill. Humidifier runs continuously, %RH is well over set-point. Humidifier runs continuously, %RH is well under set-point. Humidifier does not drain when manual drain. Dispersion tube spits water or water is present in duct Water in bottom of cabinet Diagnostics Page Page Page Page Page Page Page Page Page Page Page Item No. Electrical Compartment and Front Panel Part No. Item No. Water Compartment Part No. Item No. Steam Generator Part No. HC-6100 HC-6100 DI HC-6300 Heating Elements TC= Thermocouple Item No. Electrical Compartment and Front Panel Part No. Item No. Water Compartment Part No. Item No. Water Compartment Part No. Page Page Procedure of HC6000 Version 7 Soft Refresh Page Page Introduction to Communications Table 46-1 Modbus Variable Lists Table 47-1. BACnet Variable List Table 48-1. LonWorks Variable List Physical Data, Capacities and Dimensional Drawings Figure 49-1. Models HC-6100 and HC-6300 Physical Data, Capacities and Dimensional Drawings Figure 135-1. Models HC-6500 and HC-6700 Front, Side, Top Views Armstrong International, Inc. Limited Warranty and Remedy