Step, Door Header Assembly | Arrow Plastic CL72-A guide

Step 1	● Parts Needed For ●
Step 1	Door Header Assembly
BJ14

●9440 Door Header (one)

●9442 Starter Strip (one)

The door header reinforces the front wall and roof. It is made up of two pieces.

1Positioning the door header as shown, attach a starter strip to head- er using four screws, where shown.

9442

9440

Screw

STEP

1

14

Image 14

Arrow Plastic CL72-A owner manual Step, Door Header Assembly

Contents

Model No. CL72-A Before YOU Begin Plan Ahead Required Eye Goggles No Phillips Screwdriver Safety First Care & Maintenance Other Tips Accessories Anchor KIT This WAS Left Blank Intentionally This WAS Left Blank Intentionally Foundation Foundation For Your Building Anchoring Anchoring Down The Building Hardware Parts List Assembly by Key No Door Header Assembly Step Door Assembly Sharp Edge Floor Frame Assembly Corners/Side Angles 1Position right & left front corner Frames Wall Panels/Rear Header Gables/Roof Rafters Door Jambs Roof Panel/Trim 4Attach the right & left roof trim to Shelving/Mid Frame/Track 4Fasten the track tool holder across Door Installation CL72-A