|
| ● Parts Needed For ● | ● 9436 Right Roof Trim (one) |
|
| Step 9 | ● 9437 Left Roof Trim (one) |
| |
| Roof Panel/Trim | ● 9438 Front Roof Trim (one) |
| |
| ● 9439 Peak Trim (one) |
| ||
| BJ22 |
| ● 9443 Roof Panel (one) |
|
|
|
|
|
|
|
|
|
|
|
Each screw and bolt in the roof re- quire a washer.
NOTE
Measure the building diagonally again and make adjustments to make sure the building is square. This will make the roof panel fit better, and holes will align.
1Position roof panel on top and fas-
ten to rear header, roof rafters and gables using screws.
2Attach the peak trim to the rear of
3Fasten front roof trim to the front
flange on roof panel using five bolts and nuts, as shown.
4Attach the right & left roof trim to
the ends of the roof panel on each side of the building using two screws on each trim.
5Fasten a roof trim cap to the peak
of the right and left roof trim using a screw. Attach remaining caps upside down to the ends of the front roof trim using a screw.
STEP
5
roof using four screws into the rear |
|
|
| STEP | ||
header. |
|
|
| STEP |
| 2 |
STEP | Roof Trim Cap |
| 1 |
| ||
|
|
|
| |||
|
|
| 9439 | |||
| 4 | 9437 | Screw |
| ||
|
|
|
| |||
|
|
|
|
|
| |
Nut
Washer
9443
9436
Roof Trim Cap
Bolt9438
STEP
3
22
