Operator Manual – PE Series Amplifiers | Page - 11 |
Measurements
The following graphs are actual measurements from
Gain vs. frequency, Ch1, Ch2 - (typical performance) | Gain vs. frequency / positions of HPF, Ch1, Ch2 |
Phase vs. frequency, Ch1, Ch2 | Phase vs. frequency / positions of |
Output impedance vs. frequency @ 1 Amp RMS injected current | THD+N @ 1 kHz, 8 load vs. input voltage, Ch1, Ch2 |
(Ch1, Ch2) equivalent 11 m + 2,1 μH |
|
Damping factor into 8 , Ch1, Ch2 equation: damping factor = | THD+N vs. frequency (BW 22 kHz), |
loaded impedance / amplifier output impedance | 10 dB below clip, 8, Ch1, Ch2 |
CCIF difference frequency method (10,5 kHz and 11,5 kHz) vs. input | SMPTE intermodulation distortion (60 Hz and 7 kHz) |
level @ 8 , Ch1, Ch2 | @ 8 vs. input level, Ch1, Ch2 |
Common mode rejection ratio (Ch1, Ch2) | Channel separation vs. frequency |
@ 10 W / 8 (Ch1 => Ch2, Ch2 => Ch1)
Important Safety
Instructions – 2
Introduction - 3
The PE Series - 4
Physical Description - 5
Installation – 6
Operation – 8
Troubleshooting - 9
Spec Table - 10
Measurements - 11
Dimensions - 12
Warranty - 13
All Rights Reserved