Asko D3152 Rinse aid, Adding rinse aid, To fill with rinse aid, Machines with refill indicator

Rinse aid

Adding rinse aid

In some cases, drying can be made more ef- ficient by using rinse aid.

Machines with indicator on the panel When the rinse aid has run out and more is needed, the rinse aid symbol on the panel lights up*.

To fill with rinse aid:

1.Turn and lift up the cover of the rinse aid compartment to the right of the dispenser. This is where you top up and set the amount of rinse aid to be dispensed in each wash.

2.Carefully pour in rinse aid up to the dos- age setting knob.

Alter dosage if required. Do not forget to close the cover.

*Note!

After filling there may be a short delay be- fore the signal light goes out.

Machines with refill indicator

There is a refill indicator in the middle of the dispenser (see illustration). If the refill indica- tor is totally black, there is sufficient rinse aid. However, if the indicator has a more transparent appearance, you need to top up with rinse aid (see above).

Open

Refill indicator

Closed

Cover for rinse aid

Open by turning and lifting the cover!

Select dosage

The dispenser is usually set at 1= soft water. However, depending on the water hardness, you may need to change the dosage.

Open the rinse aid cover. Here you will find the dispenser’s adjustment dial. Settings 1-6: the harder the water, the higher the dosage.

When the water hardness exceeds 10-12 odH, you should use rinse aid with citric acid (acid rinse aid) if the machine does not have a wa- ter softening filter. If the machine has a water softening filter, dispense as for soft water.

Too much rinse aid can lead to the build- up of foam. If your water is particularly soft, you can dilute the rinse aid (1 part rinse aid, 1 part water).

Too much rinse aid can cause streaks on the dishes, while too little can result in water stains.

Customer Care Center

201-800-898-1879 www.askousa.com