Asko W6641 W661 Installation Instructions, Specifications, Removing the Shipping Supports

INSTALLATION INSTRUCTIONS

Read these instructions carefully and completely before you install the machine. The installation should be carried out by a qualified person who is familiar with all local codes and ordinances for electrical and plumbing connections.

IMPORTANT NOTE:

Cosmetic damage must be reported to your dealer within five days from the date of purchase. After unpacking the washer, thoroughly check the unit for cosmetic damage.

SPECIFICATIONS

Height	33-1/2”–34-1/2 (850–876 mm)
Width	23-7/16” (595 mm)
Depth	W6641/W6661:	23-7/16" (595 mm)
	W6021/W6221:	24-7/16” (620 mm)
Weight	167 lbs. (73 kg)
Rated load	See data plate
Supply voltage	Single-phase 230 V, 60 Hz
Heating element	2000 W
Fuse	15 A (2 internal fuses)

Drum and Barrel	Stainless steel
Outer casing	Stove-enamelled hot-dipped
	galvanized steel or stainless steel
Mounting	Four adjustable rubber-covered
	feet
Inlet supply hose	5 ft. (1.5 m) PEX tubing with
	brass ferrules
Supply pressure	15–142 PSI
Outlet hose	5.5 ft. (1.7 m) polypropylene hose,
	3/4” ID

REMOVING THE SHIPPING SUPPORTS

The machine is transported with three shipping supports, as illustrated below. These supports hold the tub in place during shipment. When you unpack the machine, you must remove these supports.

You must remove the shipping supports before you install the washer.

To remove the shipping supports, follow the instructions below:

1.Unscrew the 5/8” (12

mm)bolts holding the

supports in place and remove the bolts.

2.Push the rubber spacer up then pull it out of the slot.

3.Rotate the spacer so that the extruded end points toward the machine.

4.Insert it into the slot and push down to lock it into position.

LEVELING THE MACHINE

It is important that the machine is level so it won’t vibrate excessively during the spinning cycles. Each foot on the washer is adjustable, so you can level the washer on any surface. Once it is level, securely tighten the lock nuts on the feet to prevent excessive vibration during the spin cycles.

Be sure to tighten the lock nuts securely when you level the machine.

WATER SUPPLY CONNECTION

Because ASKO washers have their own heating element, you only need to have a cold water inlet. The connection should be made by someone who is sufficiently skilled. Use the hose supplied with the washer.

Water pressure must be in the range of 15–146 PSI. A tap should be fitted on the water supply pipe.

If a new supply pipe has been installed for the washer, it should be flushed thoroughly to remove any foreign particles that might clog the strainer in the water inlet.

Tap

Cold water supply

NOTE: If unit is installed on a second story, follow local building codes. We recommend a drip pan be installed.

Page 4