Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard!
•
Floppy Connector
(see p.2 No. 21)
the
Note: Make sure the
Primary IDE connector (Blue)
connect the blue end | connect the black end |
to the motherboard | to the IDE devices |
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_1 (PORT 0): |
|
| |
see p.2, No. 17) |
|
| |
(SATAII_2 (PORT 1): |
| SATAII_3 SATAII_4 | |
|
| ||
see p.2, No. 16) |
| (PORT 2) (PORT 3) | |
(SATAII_3 (PORT 2): |
|
| |
see p.2, No. 13) | SATAII_1 | SATAII_2 | |
(SATAII_4 (PORT 3): | |||
(PORT 0) | (PORT 1) | ||
see p.2, No. 14) | |||
|
|
These four Serial ATAII (SATAII) connectors support SATAII
or SATA hard disk for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate.
English
Serial ATA (SATA) | Either end of the SATA data cable |
Data Cable | can be connected to the SATA / |
(Optional) | SATAII hard disk or the SATAII |
| connector on this motherboard. |
1 8
ASRock