3.HARDWARE SETUP
3.5System Memory (DIMM)
This motherboard uses only Dual Inline Memory Modules (DIMMs). Two sockets are available for 3.3Volt (power level) unbuffered Synchronous Dynamic Random Access Memory (SDRAM) of 8, 16, 32, 64, 128, 256, or 512MB to form a memory size between 8MB to 1GB. One side (with memory chips) of the DIMM takes up one row on the motherboard. This motherboard also supports NEC’s Virtual Channel (VC) SDRAMs.
Memory speed setup is recommended through SDRAM Configuration under “Chipset Features Setup”.
IMPORTANT (see General DIMM Notes below for more):•SDRAMs used must be compatible with the current Intel PC133 SDRAM specification.
•DO NOT attempt to mix PC133 SDRAMs with VCM SDRAMs.•The motherboard only supports PC100 / PC133 DIMMs or VC SDRAMs for system memory. Registered DIMMs are not supported.
Install memory in any combination as follows:DIMM Location | Total Memory | |
Socket 1 (Rows 0&1) | SDRAM 8, 16, 32, 64, 128, 256, 512MB | x1 |
|
|
|
Socket 2 (Rows 2&3) | SDRAM 8, 16, 32, 64, 128, 256, 512MB | x1 |
|
|
|
| Total System Memory (Max 1024MB) | = |
|
|
|
3.5.1 General DIMM Notes
•DIMMs that have more than 18 chips are not supported on this motherboard.
• For the system CPU bus to operate at 100 MHz/133MHz, use only
•ASUS motherboards support SPD (Serial Presence Detect) DIMMs. This is the memory of choice for best performance vs. stability.
•BIOS shows SDRAM memory on bootup screen.
•
WARNING! Be sure that the DIMM you use can handle the specified SDRAM MHz or else bootup will not be possible.
.3 SETUPH/W
System Memory
ASUS | 19 |