3.HARDWARE SETUP

11)Floppy Disk Drive Connector (34-1 pin FLOPPY)

This connector supports the provided floppy drive ribbon cable. After connect- ing the single end to the board, connect the two plugs on the other end to the floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta- tion when using ribbon cables with pin 5 plugged).

NOTE: Orient the red markings on the floppy ribbon cable to PIN 1

PIN 1

A7VL-VM

A7VL-VM Floppy Disk Drive Connector

H/WSETUP

Connectors

3.

 

 

 

12)Chassis Intrusion Lead (4-1 pin CHASS)

This requires an external detection mechanism such as a chassis intrusion moni- tor/sensor or microswitch. The sensor is triggered when a high level signal is sent to the Chassis Signal lead, which occurs when a panel switch or light detec- tor is triggered. This function works with an optional ASUS CIDB chassis intru- sion module (see your vendor for more information). If the chassis intrusion lead is not used, a jumper cap must be placed over the pins to close the circuit.

CHASSIS

Ground

Chassis Signal

 

+5Volt

1

(Power Supply Stand By)

 

A7VL-VM

A7VL-VM Chassis Open Alarm Lead

ASUS A7VL-VM User’s Manual

29