
.3
H/WConnectors
SETUP
3.HARDWARE SETUP
13)Standard Infrared Module ConnectorThis connector supports an optional wireless transmitting and receiving infrared module. This module mounts to a small opening on system cases that support this feature. You must also configure the setting through UART2 Use Infrared (see 4.4.2 I/O Device Configuration) to select whether UART2 is directed for use with COM2 or IrDA. Use the five pins as shown in Back View and connect a ribbon cable from the module to the motherboard’s SIR connector according to the pin definitions.
| 
 | IR | Front View | Back View | 
 | 
| 
 | 
 | 
 | 
 | |
| 1 | 
 | 
 | 
 | 
 | 
| +5V | IRRX GND | IRTX | 
 | 
 | 
| 
 | 
 | 
 | IRTX | +5V | 
| 
 | 
 | 
 | GND | (NC) | 
| 
 | 
 | 
 | IRRX | 
 | 
This connector connects to a LAN card with a 
IMPORTANT: This feature requires that 
IMPORTANT: Requires an ATX power supply with at least 720mA +5 volt standby power
WOL_CON
Ground
| PME +5 Volt Standby | |
| 
 | 
| 30 | ASUS  |