EPP Version [1.9]

Allows selection of the Parallel Port EPP version. This item appears only when the Parallel Port Mode is set to EPP. Configuration options: [1.9] [1.7]

Parallel Port IRQ [IRQ7]

Configuration options: [IRQ5] [IRQ7]

PS/2 Mouse Support [Enabled]

Allows you to enable or disable support for PS/2 mouse. Configuration options: [Disabled] [Enabled] [Auto]

4.4.4 IDE Configuration

The items in this menu allow you to set or change the configurations for the IDE devices installed in the system. Select an item then press Enter if you wish to configure the item.

IDE Configuration

 

 

IDE Channel Selection

[Both]

S-ATA Running Enhanced Mode

[Yes]

Configure S-ATA

as RAID

[No]

IDE Detect Time out

(Sec)

[35]

ATA(PI) 80Pin Cable

Detection [Host & Device]

Allows BIOS to enable or disable the floppy drive controller.

IDE Channel Selection [Both]

Allows you to select the IDE channel that you wish to enable. Configuration options: [Disabled] [Primary] [Secondary] [Both]

S-ATA Running Enhanced Mode [Yes]

When set to Yes, allows you to configure the Serial ATA channel as a tertiary IDE channel. Configuration options: [Yes] [No]

Configure S-ATA as RAID [No]

When set to Yes, allows you to configure the Serial ATA devices into a disk array. Configuration options: [No] [Yes]

4-22

Chapter 4: BIOS Setup