3.3Attaching the rack rails
To attach the rack rails:
1.Select two units of space (2U) on the rack where you wish to install the barebone server.
2.Remove the screws from the 2U space on the rack front.
3.Remove the screws from the corresponding 2U space on the rack rear.
4.Measure the depth of the rack to determine the length of the rack rails.
5.Take three pieces of rack rail, consisting of the middle piece, one front end (with stopper tab), and one rear end (without stopper tab). Assemble the rack rail to a length depending on the rack depth.
Rear end
Front end
Stopper tabs
6.Secure the pieces together with two pairs of
Chapter 3: Installation options |