4.2.2 Jumpers
1.CPU clock setting (3-pin CLKSEL)
This jumper allows you to select the CPU frequency. Set to Auto (pins 1-2) to allow automatic frequency selection depending on the type of the installed CPU. Set to pins 2-3 if you installed a 100MHz CPU.
Remove the jumper cap to manually select the CPU frequency using the DIP switches.
CLKSEL
2 | 1 | 3 | 2 | 3 2 | 1 |
Auto | Foster | Select |
(Default) | | | by CLKSW |
PR-DLS533
PR-DLS533 CLK Setting
2.Gigabit LAN2 controller setting (3-pin LAN_SW)
This jumper allows you to enable or disable the 32-bit Intel® 82540EM Gigabit LAN controller. Setting this jumper to pins 2-3 disables the Gigabit LAN port (RJ-45) on the rear panel that corresponds to this controller.
LAN_SW
Enable Disable (Default)
PR-DLS533
PR-DLS533 LAN_SW Setting
ASUS AP2400R-E1 2U barebone server | 4-5 |
