4.4.2Chipset Configuration
This menu shows the chipset configuration settings. Select an item then press <Enter> to display a
PhoenixBIOS Setup Utility
|
|
| Advanced |
|
|
|
|
| |
|
|
|
|
| Chipset Configuration |
| Item Specific Help | ||
|
|
|
|
|
|
| |||
| Crystal Beach Configure Enable |
| [Enabled] | Enable Configuration/ | |||||
| SERR Signal Condition |
| [None] | Memory mapped accesses | |||||
| Demand Scrub Enable |
| [Enabled] | to the Crystal Beach | |||||
| Patrol Scrub Enable |
| [Enabled] | ||||||
|
| Configuration space | |||||||
|
|
|
|
|
|
|
| ||
| 4GB PCI Hole Granularity |
| [256 MB] | located in | |||||
| Memory Branch Mode |
| [Interleave] | Device 8, Fn 0, and Fn 1. | |||||
| Branch 0 | Rank Interleave |
| [4:1] |
|
| |||
| Branch 0 | Rank Sparing |
| [Disabled] |
|
| |||
| Branch 1 | Rank Interleave |
| [4:1] |
|
| |||
| Branch 1 | Rank Sparing |
| [Disabled] |
|
| |||
| Enhanced | x8 Detection |
| [Enabled] |
|
| |||
| Force ITK Config Clocking |
| [Disabled] |
|
| ||||
| FBDIMM(s) Thermal Throttling |
| [Open Loop] |
|
| ||||
|
|
|
|
|
|
|
|
|
|
| F1 | Help | ↑↓ | Select Item | Change Values | F9 | Setup Defaults | ||
| ESC | Exit | →← | Select Menu | Enter | Select | F10 | Save and Exit | |
|
|
|
|
|
|
|
|
|
|
Scroll down to display the following item:
Open Loop Type |
|
| [Best Performan] |
|
| |||
Environment Temperature |
| [025 | ºC] |
|
| |||
Temperature Rise |
| [025 | ºC] |
|
| |||
FBDIMM(s) Air Flow |
| [2.0] |
|
|
| |||
F1 | Help | ↑↓ | Select Item | Change Values | F9 | Setup Defaults | ||
ESC | Exit | →← | Select Menu | Enter | Select | F10 | Save and Exit | |
|
|
|
|
|
|
|
|
|
Crystal Beach Configure Enable [Enabled]
Allows you to enable or disable the Configuration/Memory mapped accesses to the Crystal Beach Configuration space located in Device 8, Fn 0, and Fn 1. Configuration options: [Disabled] [Enabled]
SERR Signal Condition [Single Bit]
Allows you to select the ECC error that the SERR# asserts.
Configuration options: [None] [Single Bit] [Multiple Bit] [Both]
Demand Scrub Enable [Enabled]
Enables or disables the Demand Scrubbing.
Configuration options: [Disabled] [Enabled]
Patrol Scrub Enable [Enabled]
Enables or disables the Patrol Scrubbing.
Configuration options: [Disabled] [Enabled]
Chapter 4: BIOS setup |