1.5.2Memory configurations

You may install 1GB, 2GB, 4GB, and 8GB unbuffered non-ECC DDR3 DIMMs into the DIMM sockets.

•You may install varying memory sizes in Channel A and Channel B. The system maps

the total size of the lower-sized channel for the dual-channel configuration. Any excess memory from the higher-sized channel is then mapped for single-channel operation.

•Always install DIMMs with the same CAS latency. For optimal compatibility, we recommend that you install memory modules of the same version or date code (D/C) from the same vendor. Check with the retailer to get the correct memory modules.

•Memory module with memory frequency higher than 2133 MHz and its corresponding timing or the loaded XMP Profile is not the JEDEC memory standard. The stability and compatibility of these memory modules depend on the CPU's capabilities and other installed devices.

•Due to the memory address limitation on 32-bit Windows® OS, when you install 4GB or more memory on the motherboard, the actual usable memory for the OS can be about 3GB or less. For effective use of memory, we recommend that you do any of the following:

-Use a maximum of 3GB system memory if you are using a 32-bit Windows® OS.

-Install a 64-bit Windows® OS when you want to install 4GB or more on the motherboard.

•This motherboard does not support DIMMs made up of 512Mb (64MB) chips or less.

• The default memory operation frequency is dependent on its Serial Presence Detect (SPD), which is the standard way of accessing information from a memory module. Under the default state, some memory modules for overclocking may operate at a lower frequency than the vendor-marked value. To operate at the vendor-marked or at a higher frequency, refer to section 2.4 Ai Tweaker menu for manual memory frequency adjustment.

•For system stability, use a more efficient memory cooling system to support a full memory load (2 DIMMs) or overclocking condition.

H61M Series Motherboard Qualified Vendors Lists (QVL)

DDR3 2400 (O.C.) MHz capability

Vendors

Part No.

Size

SS/DS

Chip Brand

Chip NO. Timing

Voltage

DIMM socket support

(Optional)

2 DIMMs

 

 

 

 

 

 

 

 

1 DIMM

G.SKILL

F3-2400C10D-8GTX(XMP)

8GB(2x 4GB)

SS

-

-

10-12-12-31

1.65V

•

•

G.SKILL

F3-19200CL 10Q-32GBZHD(XMP)

8GB

DS

-

-

10-12-12-31

1.65V

•

•

KINGSTON

KHX24C11T2K2/8X(XMP)

4GB

DS

-

-

-

1.65V

•

•

• DDR3 1600 MHz and higher memory frequency is supported by Intel® 3rd generation processors.

•Due to the CPU behavior, DDR3 2133/1866 memory modules runs at DDR3

2000/1800 MHz frequencies.

ASUS H61M Series

1-13