2.7.2Internal connectors

1.Floppy disk drive connector (34-1 pin FLOPPY)

This connector is for the provided floppy disk drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection when using a FDD cable with a covered Pin 5.

L1N64-SLI WS

FLOPPY

PIN 1

NOTE: Orient the red markings on the floppy ribbon cable to PIN 1.

L1N64-SLI WS Floppy disk drive connector

2.NVIDIA® IDE connector (40-1 pin PRI_IDE)

The onboard IDE connector is for the Ultra DMA (133/)100/66 signal cable. There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard’s IDE connector, then select one of the following modes to configure your device.

PRI_IDE

NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.

L1N64-SLI

WS

L1N64-SLI WS IDE connector

ASUS L1N64-SLI WS

2-23