Asus M2R-FVM manual SATA1, 2, 3, Extended Drive Auto, Extended IDE Drive, F10 Save and Exit

2.3.6 SATA1, 2, 3, 4

While entering Setup, the BIOS automatically detects the presence of Serial ATA devices. There is a separate sub-menu for each SATA device. Select a device item then press <Enter> to display the SATA device information.

Phoenix-Award BIOS CMOS Setup Utility

Main

	First SATA Master			Select Menu
Auto Acoustic Management		Disabled		Item Specific Help
				Selects the type of fixed
Extended IDE Drive		[Auto]		disk connected to the
Access Mode		[Auto]		system.
Capacity		0	MB
Cylinder		0
Head		0
Precomp		0
Landing Zone		0
Sector		0
F1:Help	↑↓ : Select Item		-/+: Change Value	F5: Setup Defaults
ESC: Exit	→←: Select Menu	Enter: Select SubMenu		F10: Save and Exit

The BIOS automatically detects the values opposite the dimmed items (Capacity, Cylinder, Head, Landing Zone and Sector). These values are not user-configurable. These items show 0 if no SATA device is installed in the system.

Extended Drive [Auto]

Selects the type of fixed disk connected to the system.

Configuration options: [None] [Auto]

Access Mode [Auto]

Sets the sector addressing mode. Configuration options: [Large] [Auto]

Before attempting to configure a hard disk drive, make sure you have the correct configuration information supplied by the drive manufacturer. Incorrect settings may cause the system to fail to recognize the installed hard disk.

Capacity

Displays the auto-detected hard disk capacity. This item is not configurable.

Cylinder

Shows the number of the hard disk cylinders. This item is not configurable.

2-14 Chapter 2: BIOS setup