5.4.4Marvell® RAID configurations
The Marvell® 6121 Serial ATA controller allows you to configure RAID 0 and RAID 1 sets on the Serial ATA hard disk drives.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID set(s). To do this:
1.Install two internal Serial ATA hard disk drives to the SATA connectors labeled SATA_RAID1/2.
2.Boot up your computer, and press <Del> during POST to enter the BIOS setup.
3.In the Advanced Menu, go to Onboard Devices Configuration, and enable both Marvell 6121 SATA Controller and Marvell Option ROM.
4.Set Marvell IDE/RAID function to [RAID].
|
|
|
| BIOS SETUP UTILITY |
| |
|
| Advanced |
|
|
|
|
| Onboard Devices Configuraiton |
|
| Allows BIOS to select | ||
|
|
|
|
|
| Serial Port1 Base |
|
|
|
|
|
| |
| Serial Port1 Address | [3F8/IRQ4] | Addresses. | |||
|
| |||||
| Serial Port1 Mode | [Normal] |
| |||
| HD Audio Azalia Device | [Auto] |
| |||
| Front Panel support Type | [HD Audio] |
| |||
| Onboard Lan | [Enable] |
| |||
| Onboard Lan Boot Rom | [Disabled] |
| |||
| Marvell 6111 SATA Controller | [Enable] |
|
| ||
| Marvell 6121 SATA Controller | [Enable] |
|
| ||
| Marvell Option ROM | [Enable] |
| Select Screen | ||
| Marvell IDE/RAID function | [RAID] |
| |||
| Primary Display Adapter |
| Select Item | |||
+- | Change Option |
F1 | General Help |
F10 | Save and Exit |
ESC | Exit |
v02.61 (C)Copyright
3.Press <F10> to save the changes and exit.
The RAID BIOS setup screens shown in this section are for reference only, and may not exactly match the items on your screen.
ASUS |