2.7.2 I nternal connectors

1. Fl oppy di sk dri ve connector (34-1 pi n FLOPPY)

This connector is for the provided floppy disk drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection when using a FDD cable with a covered Pin 5.

P5WDG2-WS PRO

FLOPPY

NOTE: Orient the red markings on the floppy ribbon cable to PIN 1.

PIN 1

P5WDG2-WS PRO Floppy disk drive connector

2. Pri mary I DE connector (40-1 pi n PRI _I DE)

The onboard IDE connector is for the Ultra DMA (133/)100/66 signal cable. There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard’s IDE connector, then select one of the following modes to configure your device.

P5WDG2-WS PRO PRI_IDE

P5WDG2-WS PRO IDE connector

NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.

•Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable.

•Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

2-32

Chapter 2: Hardware information