Drive jumper

Mode

Cable

 

 

 

setting

of device(s)

connector

 

Single device

Cable-Select or Master -

Black

 

 

Two devices

Cable-Select

Master

Black

 

 

 

 

Slave

Gray

 

 

 

 

 

 

 

 

 

Master

Master

Black or gray

 

 

 

Slave

Slave

 

 

 

 

 

 

 

If any device jumper is set as “Cable-Select,” make sure all other device jumpers have the same setting.

3. I CH 7R Seri al ATA connectors (7-pi n SATA1 [ red],

SATA2 [ red], SATA3 [ bl ack], SATA4 [ bl ack] )

These connectors are for Serial ATA signal cables for Serial ATA hard disk drives.

If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID 1, RAID 10, and RAID 5 configuration with the Intel® Matrix Storage Technology through the onboard Intel® ICH7R RAID controller.

•These connectors are set to Standard IDE mode by default. In

Standard IDE mode, you can connect Serial ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA RAID set using these connectors, set the Configure SATA As item in the BIOS to [RAID]. See section “4.3.6 IDE Configuration” for details.

•For RAID 5, use at least three hard disk drives. For RAID 10, use at least four hard disk drives. Use two to four Serial ATA hard disk drives for each RAID 0 or RAID 1 set.

P5WDG2-WS PRO

 

GND SATA RXP3 SATA RXN3 GND SATA TXN3 SATA TXP3 GND

 

GND SATA RXP2 SATA RXN2 GND SATA TXN2 SATA TXP2 GND

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SATA4

GND SATA_RXP1 SATA_RXN1 GND SATA_TXN1 SATA_TXP1 GND

SATA3

GND SATA_RXP0 SATA_RXN0 GND SATA_TXN0 SATA_TXP0 GND

P5WDG2-WS PRO SATA connectors

SATA2SATA1

ASUS P5WDG2 WS Professional/P5WDG2 WS PRO/WiFi-AP

2-33