6.2.4Creating a RAID 1 set (Mirror)

To create a RAID 1 set for Fault Tolerance:

1.Follow steps 1 to 2 of the Creating a RAID 0 set section.

2.Select RAID-1 (Fault Tolerance)from the Select RAID Type menu, then press <Enter>.

Refer to the Mirroring Requirements note at the bottom of the screen to determine the number of hard disk drives required for the selected RAID type.

3.Use the arrow keys to select a RAID set member, then press <SpaceBar> to mark. An X mark appears after the selected HDD.

4.Follow step 3 to select the other members of the RAID set, then press <Enter> when finished.

6 - 10

Chapter 6: RAID configuration