5.SOFTWARE SETUP

5.4.1Installing the Hard Disks

The RAID 0 setting allows users to reformat two hard disks with the same new OS simultaneously. RAID 1 arrays can use a pre-existing hard disk along with a blank hard disk, or two new hard disks.

1.Install the first and second hard disk into the hard disk bays of your system. Connect each hard disk drive with a separate UltraDMA/100 cable, one to the Primary ATA IDE1 connector, and the other to the Secondary ATA IDE2 connector onboard the TUSL2.

2.Connect the power cables to the hard disks.

3.Ensure that the ATA/100 / RAID 0/1 jumper 3 is reset from the default to [1-2]. (See: Section 3.4.2, Hardware Setup: Motherboard Settings)

4.Boot-up the PC.

5.4.2 Enter FastTrak100 BIOS and FastBuild Utility

1.If this is the first time you have booted with two hard disks correctly installed, then FastTrak100™ “Lite” BIOS scans the IDE drives and displays this screen:

2. Press <Ctrl-F>keys to display the FastBuild™ Utility Main Menu:

FastBuild (tm) Utility 1.31 (c) 1996-2000 Promise Technology, Inc.

[ Main Menu ]

Auto Setup . . . . . . . . . . [[ 11 ]]

View Drive Assignments . . . . [[ 22 ]]

View Array . . . . . . . . . . [[ 33 ]]

Delete Array . . . . . . . . . [[ 44 ]]

Rebuild Array. . . . . . . . . [[ 55 ]]

Controller Configuration . . . [[ 66 ]]

[ Keys Available ]

Press 1..6 to select Option

[ESC] Exit

 

 

5. S/W SETUP

RAID

ASUS TUSL2 User’s Manual

85