I N C A S EO F D I F F I C U L T
If you have difficulty operating this product, try the suggestions below. For Customer Service,visit our website at u)uxa.telepb ones.att. com or call
1
MessagesAre Incomplete
. The system can accept messagesup to three minutes long. If a caller leaves a very long message,part of it might be lost when the system disconnects the call after three minutes.
. If the caller pauses for more than seven seconds,the system stops recording and disconnects the call.
. If the system'smemory fills up dunilf" a message, the system stops recording and disconnects the call.
System Will l{ot Record Messages
. When memory is full, saved messages
| must be deleted before new messages | |
| can be recorded. |
|
| If B0 (announce only) is selected, no | _= |
| messageswill be recorded. | |
Incoming Messagesare ilot Heard |
| |
During Recording |
| |
. | PressVOLLllEI until |
|
| desiredlevel. |
|
. | Make sure Call Screening is not set |
|
| to OFE |
|
System Takes Longer Than Usual To Respond
If there are many messagesrecorded, the system may take longer than usual to respond audibly.
System Does Not Respond To Remote Commands
. Make sure you are calling from a touch tone phone . When you dial a number, you should hear tones. Ifyou hear clicks instead, the phone is not a touch tone telephone.
. The answering system may not detect the RemoteAccess Code while your announcement is playing. Try waiting until the announcement is over before entering the code .
. There may be noise interference on the phone line you are using. Press dial buttons firmly.
. Make sure you are entering your RemoteAccess Code correctly.
. You might be calling from a phone that sends tones too short for your answering system to detect.
. If there are many messagesrecorded, the system may take longer than usual to respond.
System DoesNot Anqwelfter Correc!_*- Numberof Rings
If the Toll Saverfeature is on, the number of rings changes from four to two. or six to four, when you
oIn some cases,the system might be affected by the ringing system used by the local telephone company.
If the system'smemory is full or the system is off, the system answers after 1Orings .
When NumberAnnounce is on and Number of Rings is set to 2, system answers after three rings so it can announce caller'snumber.
If ffO(announce only) is selected and no announcement is recorded, system
answers after 1Orings and announces "No announcement."
9
