Mitsubishi Electronics FR-A700, 700 Series Setting list of built-in PLC function parameter

Function Block Diagram

1.5.5Setting list of built-in PLC function parameter

The built-in PLC function parameters are designed to specify the ranges of using the PLC function, e.g. program capacity, device assignment and various functions.

Item	GX Developer Default	Setting Range
		<Usable device range>
Sequence program	6k steps	1k step
capacity
File register capacity	None	Cannot be set (default)
Comment capacity	None	Cannot be set (default)
Status latch	None	Cannot be set (default)
Sampling trace	None	Cannot be set (default)
Microcomputer program	None	Cannot be set (default)
capacity
Latch range setting	L1000 to L2047	Cannot be set (invalid if set)
Link range setting	None	Cannot be set (default)
I/O assignment	None	Cannot be set (default)
Internal relay, latch relay,	M0 to 999	L and S cannot be set.
	L1000 to 2047	(Operates as M if set)
step relay setting
	None for S	<M0 to M63>
Watchdog timer setting	200ms	10 to 2000ms
	100ms: T0 to 199	16 points for 100ms, 10ms and
Timer setting	10ms: T200 to 255	retentive timers. Timers have
	(100ms timers since only T0 to 7	consecutive numbers.
	are available)	<T0 to T15>
Counter setting	Without interrupt counters	Cannot be set (default)
		<C0 to C15>
		Can be set using X0 to 1F.
Remote run/pause	None	Otherwise invalid. Pause does not
		function.
	Fuse blow: Continued	Setting invalid (since there are no
		fuses)
	I/O verify error: Stop	Setting invalid
Error-time operation mode		(since there are no I/O modules)
	Operation error: Continued	Stop/Continued
	Special function module check	Setting invalid (since there are no
	error: Stop	special modules)
STOP → RUN output mode	Operation status prior to	Prior to STOP/after operation
	STOP is re-output.	execution
Print title registration	None	Cannot be set
Keyword registration	None	Online setting cannot be made but
		parameter setting is valid.

REMARKS

•The following functions are not supported.

1.Constant scan, 2. Latch (device data backup for power failure), 3. Pause,

4.Status latch, 5. Sampling trace, 6. Offline switch

•If parameter clear of the inverter is performed, the above built-in PLC function parameters are not cleared.

•For the built-in PLC function parameter setting operation, refer to the GX Developer Operating Manual.

1

PLC FUNCTION

9