Mitsubishi Electronics FR-A700, 700 Series specifications Pid

Device Map

Number

	D9234
	D9235
	D9236
	D9237
	D9238
	D9239
	D9240
controlfor	D9241
	D9242
registers
	D9243
Special	D9244
	D9245
	D9246
	D9247
	D9248
	D9249
	D9250
	D9251
	D9252
	D9253
	D9254
	D9255

Name	Description	Page
Second
parameter	When setting the calibration(bias/gain) parameters.
changing (RAM)
Second	H00: Frequency(toruque)	34, 36
	H01: Parameter-set analog value
parameter	H02: Analog value input from terminal
changing
(EEPROM)
Pulse train input	The number of pulses counted in count cycle is
sampling pulse	stored. (0 to 32767)
Pulse train input
cumulative count
value L	The cumulative value of the number of sampling
Pulse train input	pulses is stored. (0 to 99999999)	40
cumulative count
value H
Reset request of	The sampling pulses and cumulative count value are
pulse train input	cleared. Automatically changes to "0" after reset.
count	(1: count clear)
Count start of the	Start counting the sampling pulses and cumulative
pulse train input	count value. (0: count stop, 1: count start)
Parameter	Set the number of parameter read or written of the
number (RAM)	inverter.
Parameter	The parameter description of the inverter (RAM value)
description	specified by D9241 is stored. Set the parameter
(RAM)	setting for parameter write.	34, 36
Parameter	Set the number of parameter read or written of the
number
	inverter.
(EEPROM)
Parameter	The parameter description of the inverter (EEPROM
description	value) specified by D9243 is stored. Set the
(EEPROM)	parameter setting for parameter write.
Terminal 1 input	Analog input value of terminal 1 (0.1% increments) is
	stored.
Terminal 2 input	Analog input value of terminal 2 (0.1% increments) is	39
	stored.
Terminal 4 input	Analog input value of terminal 4 (0.1% increments) is
	stored.
PID set point /	Set the PID set point or PID deviation (0.01% units)
PID deviation
PID	Set the PID measurement value (0.01% units)	41
measurement
value
PID manipulated	Stores the PID manipulated variable (0.01% units)
variable
Terminal FM	When Pr. 54 is set to "70", pulse train can be output
	from terminal FM. High speed pulse train output can
output
	be performed. (0.1% increments)
Terminal AM	When Pr. 158 is set to "70", analog output can be	39
output	performed from terminal AM. (0.1% increments)
AM0 output	Analog output can be performed from terminal AM0
AM1 output	and AM1 of the FR-A7AY. (0.1% increments)
PID operation	Setting 1 starts PID control.	41
control

Device Map

1

PLC FUNCTION

19