17Priority Call Signal for the System
When a caller enters the Priority Call Code from a touch tone phone,the system beeps
loudly to alert you that you have a Priority Call. You’ll need to provide select callers with
the Priority Call Code (preset to 999),in order for them to use this feature. The Priority
Call Code is the same for both lines and is set using Line 1.
1Your caller dials your telephone number from a touch tone phone.
2When the announcement begins to play,your caller enters the Priority Call Code.
3The system beeps three times,then pauses. This continues for up to 30 seconds,
unless you answer the phone.
4If you do not answer,your caller can press 5to stop the Priority Call signal and
leave a message.
Change Priority Call Code for the System
The Priority Call Code comes set to 999,but you can change it to any three-digit number
from 100 to 999. Do not set the Priority Call Code to the same number as the Remote
Access Code.
1Press o.
2Use the softkey to select ANS SYS. The screen displays Set options for which
mailbox?
3Use the softkey to select L1. The screen displays your choice.
4Select OK until the screen displays Priority Call Code.
5Press Cor cto change the first digit.
6Select NEXT to move to the second digit.
7Press Cor cto change the second digit.
8Select NEXT to move to the third digit.
9Press Cor cto change the third digit.
10 Select OK.
SET UP SYSTEM FEATURES
1782_book_1AT&T 5/1/00 7:35 PM Page 17