T E L E P H O N E O P E R A T I O N
MAKE OR ANSWER A CALL
1Lift the handset
— OR —
Press K
2Press Lor l.
ENDING A CALL
Place the handset in the cradle
— OR —
Press K(if on a speakerphone call).
AUTO REDIAL
If you place a call and hear a busy signal, hang up, and then press (. The system redials the number you just called.
When you hear the line ringing, lift the handset or press Kto talk. If you don’t do so within 60 seconds, the system hangs up. If the system detects a busy signal, it will hang up, wait 40 seconds, and try again (up to 10 times).
MUTE
To mute a call, press M. You can hear the other party, but the other party cannot hear you.
Press M again to continue
NOTE: Mute is canceled if you switch between speakerphone and handset, or if you put the call on Hold.
SWITCHING BETWEEN HANDSET AND
SPEAKERPHONE
To switch from handset to speakerphone
during a call, press K.
To switch from speakerphone to handset
during a call, lift the handset.
AUTOMATIC LINE SELECTION
The system is preset to select a line for you in most cases when you lift the handset or press K.
To change how the system selects a line,
see “Line Selection Options” later in this manual.
LINE STATUS
Line 1 and Line 2 lights indicate when a line is in use. A flashing red light indicates the line is on hold. A flashing green light indicates the line is ringing.
Each line has its own ringer tone to signal an incoming call. If you are on a call when the other line starts to ring, you will hear only one short ring, so you can continue your call without further interruption.
REDIAL
The last number dialed on this phone is stored in redial memory until you dial an- other number.
1Lift the handset
— OR —
press K
— OR —
press Lor l.
The number stored in redial memory is displayed.
2Press (.
To cancel automatic redialing, press
(or lift the handset or press K.
HOLD
Press H. You can now replace the hand- set in the cradle without disconnecting the call. The speakerphone is automatically turned off.
To take a line off hold, press the appropriate line button or lift the handset of an extension phone on that line.
The hold feature allows you to switch between calls on both lines without dis- connecting either call.
CONFERENCE CALLS
1Make or answer a call, then press c.
2Establish a call on the other line, then press c.
To end a conference call, hang up both lines. All parties will be disconnected.
If one caller hangs up during a conference call, you might hear a dial tone. Press the line button of the remaining call to eliminate the dial tone.
CONFERENCE CALL OPTIONS
To place a conference call on hold:
1Press Hto hold both lines.
2Press cto continue your conference call.
To talk privately with one caller:
1Press H.
2Press the line button of the person with whom you want to speak privately.
3Press cto continue your conference call.
To disconnect only one party from a
conference call, press the line button of the call you want to continue.
FLASH
Use h instead of pressing the switchhook to activate services such as Call Waiting or
TEMPORARY TONE
If you have rotary service, you can change from pulse to tone dialing during a call by pressing T. This is useful if you need to send tone signals for access to telephone banking or
1Dial a number.
2Press T. Buttons pressed after this will send tone signals.
3After you hang up, the phone automatically returns to rotary service.
