Assembling System Phones
You can either desk mount or wall mount a system phone. If the system phone is manufactured with a separate stand, you can use the stand to either wall mount the phone or raise the angle of the phone when desk mounting. (The stand is required for
Desk Mounting
1 A) Plug one end of the handset cord into the jack on the handset and the other end into the small jack on the left side of the base. For an
B)Plug one end of the phone cord into the jack on the bottom of the phone. If the phone has multiple jacks, plug the cord into the GRAY jack.
C)Push the cord into place along the channel on the bottom of the phone.
D)If you want to raise the angle of the phone, go to Step 2; if
2 A) To install the telephone stand (required for the
B)Insert the tab on the narrow end of the stand into the right slot on the bottom of the phone. (For an
C)Insert the other tab into the left slot, pushing the stand down and slightly inward until the tab locks into place.
3 A) Turn the phone over so it is right side up.
B)Remove the plastic cover from the phone. Label the button sheet to show any programmed lines or button features, then place it on the phone so the holes on the sheet fit over the buttons. Carefully replace the plastic cover.
C)Slide the Quick Reference card under the telephone.
Channel
Jack
Installation Procedures 13