Connecting Paging, Music-On-Hold,

and Call Reporting (SMDR) Devices

Only steps for connection to the processor module are
provided here. Refer to the manufacturer’s instructions
for additional information on installing and using these
devices.
PAGE Jack

Paging System

1Insert the modular plug into the PAGE jack on the
processor module.
2Route the cord as you did for line and extension
cords, then connect it to the paging system.

Music-on-Hold Audio Source

Paging System
(optional)
If you use equipment to broadcast certain copyrighted
music or material, including songs or other material from
radio broadcasts, you may be required to obtain the
permission of the copyright owner. One way to obtain
permission is to contact ASCAP, BMI, and/or similar
performing rights organizations, to obtain a license. Or,
you can purchase a Magic on Hold system from AT&T,
which does not require you to obtain such a license.
AT&T disclaims any liability arising out of the failure to
obtain such a license, if required.
1First set the unit’s volume to the lowest setting. Use a
flathead screwdriver to turn the volume control on the
processor module counterclockwise until it stops.
2Insert an RCA phono plug into the MUSIC ON HOLD
jack on the processor module. Audio Source
(optional)
3Route the cord as you did for line and extension
cords, and then connect it to the audio source.
4Place a call on hold and listen while adjusting the
volume, clockwise. If you do not hear music at any
setting, check “Music On Hold (#602)” in Chapter 5 of
the PARTNER Plus Communications System
Programming and Use guide.

Call Reporting (SMDR) Printer

1Insert one end of a D8W modular cord into the SMDR
jack on the processor module.
AT&T
2Plug the other end into a 355A adapter and then plug
the adapter into the printer’s RS-232C serial port.
16 Installation Procedures
Volume Control
SMDR Jack
Call Accounting
Terminal Printer
(optional)