AT&T 7650 Directory Card, Re~lacins Stored Number, Storing a Pause A Memory Dial Number

This cordless phone can store nine	MOTE: The numbers stored in m e m o p
telephone numbers that you can dial just	might be lost when you chailge the
by pressing MEMORY: and one of the	handset batteries or ifthe batteries run
number buttons.	down completely; ifthis happens. you'll
	need to store the numbers again.

ANS SYSTEM light goes on while Answering System

Change channels.

Ylight battey

larged.

Storing a Number in Memory

1Make sure the handset is OFF.

3Press %EMi%F. The PHONE light

flashes.

3Enter the phone number (up to 16

digits).

4.Press !MEMORF.

5Press any number button from 1 to 9 for the memory location where the number is to be stored.

6A three-part tone confirms that the number was stored properly. If you

hear a long buzzing tone. or nothing at all. press m,then follow the

steps above to store the number again.

NOTE: You may choose to store emergency numbers in memory locations.

Tmanufucturer assumes no responsibiliefor customer reliance lipon this memoryfeature.

Dialing a Number in Memory

1Press .pMNE'.

3 Press WMORV.

3 Press the number button (1-9)you

assigned to the number you're calling.

Directory Card

There is a directory card with an erasable surface located on the base to record names o r telephone numbers of the

r l d l ~ . L . ~ 3~;:1,1 1 ~ . ~ !a n i I L ~ L L A C ~: )\ I C c k < . ..

To write on the card, remove the plastic cover by inserting a pointed object in the hole and prying the cover up until it pops out;

Re~lacins Stored Number

You can replace a stored number by storing a new number in its place.

Storing a Pause

in a Memory Dial Number

If this phone is connected to a switchboard, you might have to dial an access number (usually 9) to get an outside line. You can store the access number and a pause in the dialing sequence; the pause allows the switchboard enough time to get an outside line dial tone.

1When storing a memory number (see above). press and hold the number button of the digit that comes just before the pause, until a second beep is heard. This inserts a I-second pause.

3You can insert a longer pause by continuing to press and hold the number button of the digit that comes before the pause. A beep is heard for each '-second pause inserted.

NOTE: Ecrchparise you store is counted as a digit. You can store up to 16 digits in euch memot? location.

For example. to store 9, PAUSE,

555-1234 in memory location 3:

Press MTMOFIY'.Press and hold 5 ,

until a second beep is heard. Then