CAUTION:
To reduce the risk
of fire or injury to persons or
damage to the telephone, read and fol-
low these instructions carefully.
For the handset, use only the
battery provided with this
phone, or AT&T Replacement
Battery
405
1.
Do not dispose of the battery in a
fire. The cell might explode.
Do not open, puncture or mutilate
the battery. Released electrolyte is
corrosive and might cause damage
to the eyes or skin. It might be toxic
if swallowed.
Charging the Handset
Battery
Pack
You'll know the batteries need charging
when:
The phone beeps four times when
you press
.
The
LOW
BATTERY
light on the
handset is on.
The
phone does not respond when
you press
(PHONE:,
and no
lights
go on.
Place the handset in the base so the
CHARGING
light goes on. The
batteries will be fully charged
in
4
hours.
Once the batteries are fully charged, you
need only put the handset in the base
when the
LOW
BATTERY
light goes on.
If
it's more convenient
for
you,
you
can leave the handset in the base all
the time. It is impossible to over-
charge the batteries.
If
you
get
a
low-battery signal
even
after
4
hours of charging, the battery
should be replaced.
Installinglfleplacin~
the Battery
Pack
Remove the battery case cover
on
the handset by pressing on the
indentation and sliding the cover
downward.
Lift
out the old battery pack
and
unplug it from the handset.
Hold the new battery pack and
plug the cord into the handset.
Place the battery pack in the case
so the cords rest on top of the
battery pack.
Replace the cover
by sliding it on
its track up over the battery case
until it snaps
firmly
in place.
The new batteries must be
charged before using the phone.
Place the handset in the base and
allow it to charge for
4
hours. The
telephone might operate before that,
but for best performance, let the
handset batteries charge fully.
Battery Case
I
0
lnstallinglReplacing
the Base Battery
The base battery provides backup power
to retain memory in case of power
failure.
1
Turn the unit over.
2
Open
the battery cover
located on
the bottom of the base, on the
upper right. Gently pull on the
moveable tab to open.
3
Connect a new 9-volt alkaline
battery
and place it in the
compartment.
1
Close the battery cover.
IMPORTANT:
Do not dispose of
batteries in household garbage. For
information about recycling or proper
disposal. consult your local solid waste
(parbage) disposal organization.