Manuals / AT&T / Communications / Cordless Telephone

AT&T 9341 Wall Installation, Charge the handset battery, Check for dial tone, Set the dial mode

Models: 9341

1 26

Download 26 pages 18.2 Kb

Page 8

Image 8

9341_book_1ATT 6/14/00 4:07 PM Page 6

INSTALLATION

3Charge the handset battery.

Place the handset in the base. Charge the battery for at least 16 hours the first time.

4Check for dial tone.

After the batteries are charged, pick up the handset and press P; you should hear a dial tone.

5Set the dial mode.

If you have touch tone service, the phone is ready to use as soon as the batteries are charged.

If you have dial pulse (rotary) service, you’ll need to change the dial mode.

•Make sure the phone is off.

•Press Gon the handset until the screen displays DIAL TYPE: and the cureently selected mode.

•Press >to select TONE or PULSE.

•Press Sto save the displayed mode.

Wall Installation

1 Position the wall mount adapter on the base.

Align tabs on wall mount adapter with holes on bottom of base. Snap wall mount adapter firmly into place.

Page 8

Image 8

AT&T 9341 user manual Wall Installation, Charge the handset battery, Check for dial tone, Set the dial mode

Contents

900 MHz Cordless Telephone with Caller ID/Call Waiting Part 1 - Important Product InformationREVISED 6/14/00 USER’S MANUAL9341book1ATT 6/14/00 407 PM Page Printed in China. XXXXXXXX Issue 1AT&T 5/002000 Advanced American Telephones. All rights reserved BEFORE YOU BEGIN CONTENTSFEATURE SETTINGS INSTALLATION9341book1ATT 6/14/00 407 PM Page BEFORE YOU BEGIN About Caller Identification Caller ID2 Install the handset battery INSTALLATIONBefore You Install Table/Desk Installation 1 Connect the telephone line cord 2 Connect the power cord3 Attach belt clip to the cordless handset optional To attachWall Installation 3 Charge the handset battery4 Check for dial tone 5 Set the dial mode2 Connect the telephone line cord 3 Connect the power cord 5 Follow Steps 3-5 in Table/Desk Installation4 Mount the base on the wall Align holes onFEATURE SETTINGS Time/DateRinger Selection Auto Answer On/OffHandset Volume Exit programming Cancel a pageTELEPHONE OPERATION Answer a Callwaiting signal when you havewhen handset If you subscribeTELEPHONE OPERATION Temporary Tone DialingHeadset Jack Operating Range Display Screen MessagesScreen Displays WhenPresses TELEPHONE MEMORYStore Memory Numbers Edit Numbers Stored in Memory Delete Numbers Stored in MemoryMove Numbers Stored in Memory Delete a Specific NumberDial Memory Numbers TELEPHONE MEMORY1 Press P 2 Press M, then enter the memory location 3 Press PCALLER ID OPERATION About Call HistoryReview Call History Indicates number of times this party has called Caller’s nameDelete Call History Dial a Displayed NumberDelete a Specific Call Delete All CallsStore Call in Memory CALLER ID OPERATIONCALLER ID OPERATION Call BlockTurn Off Call Block PRIVATE NAME PRIVATE CALLERUNKNOWN NAME UNKNOWN CALLERCharging the Handset Battery Pack BATTERIESBATTERIES Replacing the Handset Battery Pack2 Lift out the old battery pack and disconnect If you hear a two-beep signal when you try to use the handset If the phone does not ring when you receive a callIN CASE OF DIFFICULTY If the phone doesn’t work at all, check these items firstIf you hear noise or interference when using the phone If you hear other calls while using your phoneIf you lose a call after changing channels IN CASE OF DIFFICULTY