Manuals / AT&T / Communications / Cordless Telephone

AT&T 9341 user manual Installation, Before You Install, Install the handset battery

Models: 9341

1 26

Download 26 pages 18.2 Kb

Page 6

Image 6

9341_book_1ATT 6/14/00 4:07 PM Page 4

INSTALLATION

Before You Install

1Choose a location for the base near an electrical outlet and a telephone jack.

This phone requires a modular telephone jack and a standard electrical outlet (110v AC) not controlled by a wall switch.

2Install the handset battery.

a)Remove battery

compartment cover by pressing on the indentation

and sliding downward.

b) Align two holes in plug with socket pins, and snap the plug into place.

c)Place battery pack

in compartment with the wires in the lower left corner, along the bottom of the battery pack.

d) Replace cover by sliding it up into place.

Page 6

Image 6

AT&T 9341 user manual Installation, Before You Install, Install the handset battery

Contents

REVISED 6/14/00 900 MHz Cordless Telephone with Caller ID/Call WaitingPart 1 - Important Product Information USER’S MANUALPrinted in China. XXXXXXXX Issue 1AT&T 5/00 2000 Advanced American Telephones. All rights reserved9341book1ATT 6/14/00 407 PM Page FEATURE SETTINGS BEFORE YOU BEGINCONTENTS INSTALLATION9341book1ATT 6/14/00 407 PM Page BEFORE YOU BEGIN About Caller Identification Caller IDINSTALLATION Before You Install2 Install the handset battery 3 Attach belt clip to the cordless handset optional Table/Desk Installation1 Connect the telephone line cord 2 Connect the power cord To attach4 Check for dial tone Wall Installation3 Charge the handset battery 5 Set the dial mode4 Mount the base on the wall 2 Connect the telephone line cord 3 Connect the power cord5 Follow Steps 3-5 in Table/Desk Installation Align holes onRinger Selection FEATURE SETTINGSTime/Date Auto Answer On/OffTELEPHONE OPERATION Handset VolumeExit programming Cancel a page Answer a Callwhen handset waiting signalwhen you have If you subscribeTemporary Tone Dialing Headset JackTELEPHONE OPERATION Screen Displays Operating RangeDisplay Screen Messages WhenTELEPHONE MEMORY Store Memory NumbersPresses Move Numbers Stored in Memory Edit Numbers Stored in MemoryDelete Numbers Stored in Memory Delete a Specific Number1 Press P 2 Press M, then enter the memory location Dial Memory NumbersTELEPHONE MEMORY 3 Press PReview Call History CALLER ID OPERATIONAbout Call History Indicates number of times this party has called Caller’s nameDelete a Specific Call Delete Call HistoryDial a Displayed Number Delete All CallsStore Call in Memory CALLER ID OPERATIONCall Block Turn Off Call BlockCALLER ID OPERATION UNKNOWN NAME PRIVATE NAMEPRIVATE CALLER UNKNOWN CALLERCharging the Handset Battery Pack BATTERIESReplacing the Handset Battery Pack 2 Lift out the old battery pack and disconnectBATTERIES IN CASE OF DIFFICULTY If you hear a two-beep signal when you try to use the handsetIf the phone does not ring when you receive a call If the phone doesn’t work at all, check these items firstIf you lose a call after changing channels If you hear noise or interference when using the phoneIf you hear other calls while using your phone IN CASE OF DIFFICULTY