Wall Installation | AT&T 9351 specification

9351_book_2ATT 1/1/01 3:33 PM Page 5

INSTALLATION

Wall Installation

1 Position the wall mount adapter on the base.

Align tabs on wall mount adapter with holes on bottom of base. Snap wall mount adapter firmly into place.

2Connect the telephone line cord.

3Connect the power cord.

The ANSWER ON/OFF light goes on, and CL flashes in the Message Window.

Use only the power cord supplied with this product. If you need a replacement, call 1 800 222-3111.

5

Image 7

AT&T 9351 user manual Wall Installation, Position the wall mount adapter on the base

Contents

Part 1 Important Product Information Revised Advanced American Telephones. All rights reserved Contents Before You Install InstallationInstall the handset battery Attach the belt clip to the cordless handset optional Check for dial tone Table/Desk InstallationCharge the handset battery Set the dial mode Connect the telephone line cord Connect the power cord Wall InstallationPosition the wall mount adapter on the base Mount the base on the wall Follow Steps 3-5 in Table/Desk Installation Telephone Operation Page/Handset Locator Handset Ringer Style Temporary Tone DialingRinger Off Operating Range Headset Jack Telephone Memory About Announcements Audible IndicatorsAnswering System Operation About Mailboxes Press Uuntil you hear Set Outgoing Message Record Your Announcement Feature Summary Answering System Feature Setup Play Messages Adjust Playback VolumeListen To, Save & Delete Messages Delete Messages Record a Memo Call Screening/InterceptMessage Window Display Voice Menu Connect with the Answering System Remote Access Commands Batteries Charging the Handset Battery Pack Replacing the Handset Battery Pack Spare battery compartment Spare Battery Charger Case of Difficulty If the phone does not ring when you receive a callIf the phone doesn’t work at all, check these items first If messages are incomplete If you hear noise or interference when using the phoneIf you hear other calls while using your phone If you lose a call after changing channels If CL appears in the Message Window If you have difficulty hearing messagesIf your outgoing announcement isn’t clear