AT&T | Door Phone Controller | ||
|
| DIP Switch Settings | |
|
|
| |
| NOTE: All switches are OFF | The Door Phone Controller’s operating modes are selected on the | |
| when shipped from the factory. | ||
|
| used to set up the way the Door Phone Controller will interface with | |
|
| your telephone equipment. Position 8 is used to access Option Selec- | |
|
| tion Mode. Positions 6 & 7 are not used. Definition are given below: | |
|
| Switch 1 | Selects between Trunk Access and Station Access. |
|
|
| Trunk Access = OFF, Station Access = ON. |
CAUTION: Damage to the PBX Station Card may result if switch position #1 is incorrectly set. Double check that switch position #1 is set to ON for Station Port Access.
Switch 2 | Selects between Dedicated Trunk or Shared Trunk. |
| This switch only has meaning when Trunk Access |
| is selected with Switch 1. Shared Trunk = OFF, |
| Dedicated Trunk = ON. |
Switch 3 | Selects between Trunk Savor or Port Saver. This |
| switch only has meaning when Trunk Access is |
| selected with Switch 1 and Shared Trunk is |
| selected with Switch 2. Trunk Saver = OFF, Port |
| Saver = ON. |
Switch 4 | Selects between Loop Start and Ground Start. This |
| switch only has meaning when Trunk Access is |
| selected with Switch 1. Loop Start = OFF, Ground |
| Start = ON. |
Switch 5 | Selects between Auxiliary Alert or Ringdown. This |
| switch only has meaning when Station Access is |
| selected with Switch 1. Auxiliary Alert = OFF, |
| Ringdown = ON. |
Switch 6 | Not used. |
Switch 7 | Not used. |
Switch 8 | Selects between Option Selection Mode and Normal |
| Operation. This switch acts as a Option Selection |
| security switch. If this switch is ON, any user can |
| activate Option Selection Mode by keying in “##3” |
| on a |
| directly to the Door Phone Controller. When this |
| switch is OFF, Option Selection Mode cannot be |
| activated. Normal Mode = OFF, Option Selection |
| Mode = ON. |
(See other side for DTMF Option Selection.)