Installation
Mounting Instructions
The AT&T Door Phone Controller can be placed on a flat table or shelf, or mounted to a wall.
Wall Mount Instructions
When moving AT&T Door Phone Controller or adding/ removing cables from back panel, unplug transformer from 120V outlet.
Also unplug the terminal strip and modular phone connectors on the back panel.
The AT&T Door Phone Controller is shipped with a keyhole mounting template and mounting screws. Follow the steps below to mount the Door Phone Controller to a wall.
1.Place template
2.Use a Philips screwdriver to screw each of the two screws into the marked screw positions.
IMPORTANT: Do not drive screws all the way into wall; adequate space (5/16'') must be left to position the AT&T Door Phone Controller bottom panel keyholes over screw heads.
3.Mount the AT&T Door Phone Controller over the protrud- ing screw heads and seat unit firmly to the wall. See Figure
WARNING: RISK OF ELECTRICAL SHOCK — EQUIPMENT MUST BE PROPERLY GROUNDED. Your AT&T equipment requires a properly grounded
Installation Procedures |