AT&T operation manual AT&T Door Phone Controller Option Selection, Memory

AT&T Door Phone Controller — Option Selection

To Select Options: (1) Set DIP switch location 8 to the ON position. (2) Dial door speaker phone number or extension. (3) Dial ##3. (4) Program any or all of the following functions, in any order:

Options	Mode Option/	Press	Listen		Press		Listen	Default
	Verify		For				For
Delay Before	To Select Option	00	Single	000 to 255 for 0 to 255			Double	30 sec.
Door Ajar			Beep	seconds of delay after strike			Beep
Call-back	To Verify	01		plate release stops until
				Door Phone Controller calls
				back to indicate that door is
				ajar
Ring/Chime	To Select Option	10	Single	24 (for 2 sec. on 4 sec. off			Double	2 sec./
Cadence			Beep	cadence)		or	Beep	4 sec.
	To Verify	11
				15 (for 1 sec. on 5 sec. off
				cadence)
Ring/Chime	To Select Option	20	Single	00 to 99 (0 to 99 second(s)			Double	30 sec.
Duration			Beep	ring/chime)			Beep
	To Verify	21
Door Unlock	To Select Option	30	Single	4 digits (first digit must be			Double	6736
Code			Beep	0,3,4,5,6,7 or 8;			Beep	“OPEN”
	To Verify	31
				remaining digits can be set
				from 0 to 9)
Door Unlock	To Select Option	40	Single	00 to 99 (door lock active			Double	4 sec.
Duration			Beep	time in sec.)			Beep
	To Verify	41
Enable Door	To Select Option	50	Single	1	Enable door code		Double	1
Code			Beep	0	Disable door code		Beep	(Enabled)
	To Verify	51
Door Ajar	To Select Option	50	Single	2	For callback after strike		Double	2
Mode			Beep		plate release only		Beep
	To Verify	51		3	For callback anytime
					door is opened
Forced	To Select Option	60	Single	010 to 255 (unit disconnects			Double	120 sec.
Disconnect			Beep	in 10 to 255 sec.)			Beep
	To Verify	61
Time-Out
Reset Options	To Select Option	70	Single	## (to restore factory default			Double	N/A
to Factory			Beep		conditions)		Beep
	To Verify	71
Defaults
Phone	To Select Option	80	Single	0 to 20 numerical digits and			Double	#
Number			Beep	❊ ( ❊ = 2 second pause) #			Beep
Storage	To Verify	81		terminates		entry
Memory 1
Phone	To Select Option	90	Single	0 to 20 numerical digits and			Double	#
Number			Beep	❊ ( ❊ = 2 second pause) #			Beep
Storage	To Verify	91		terminates		entry
Memory 2

After Selecting Options: (1) Press ##3. (2) Hang up after hearing a double beep confirmation. (3) Set DIP location 8 back to the OFF position, to prevent unauthorized re-programming. (See other side for DIP Switch Settings.)