44
Appendix
44
Adding new handsets
Your telephone can accommodate up to four cordless handsets. You can add
new handsets (E597-1, purchased separately) to the E5917, E5938B and E5939B
at any time, but each handset must be registered with the base before use.
The handset provided with your E5917 is automatically registered as handset 1.
Additional handsets will be assigned numbers in the order they are registered
(handset 2, handset 3, or handset 4). You can register a maximum of four hand-
sets.
The E5938B has two handsets automatically registered as handset 1 and 2. You
can register two additional handsets, which will be assigned as number 3 and 4.
The E5939B has three handsets automatically registered as handset 1, 2 and 3.
You can register one additional handset, which will be assigned as number 4.
Handset 1 Handset 2 Handset 3
Handset 4
Before using a new E597-1 handset, you must regis-
ter it with the base.
To add a new handset:
• When first purchased, all optional accessory
handsets show NOT REGISTERED on the
screen.
• Make sure your handset battery is properly
installed and charged.
• Put the handset in its cradle which is plugged
into AC power. After a few seconds, PRESS
HNDST LOC 4 SEC ON BASE will be shown on
the screen.
• Press and hold HANDSET LOCATOR /INTERCOM on
the main telephone base until the IN USE light
comes on (about four seconds), then release the
button.
• The handset will show PLEASE WAIT... for a
while.
• The handset will show HS X REGISTERED and
beep once if registration was successful.
HS X REGISTERED
NOT REGISTERED
PRESS HNDST LOC
4 SEC ON BASE
NOTES:
1. If you are on a call, using the call log or directory, or another phone
is on the same line, you cannot register a handset.
2. If the registration is not successful, the display will show NOT
REGISTERED. Reset the handsets by lifting the handsets out of their
cradle and then place the handsets back in the cradle.
3. You can register only one hand-
set to the base at a time.
Telephone base