AT&T SPIRIT Attendant owner manual

6

1.Connect the SPIRIT Attendant ConnecT/R to the Controller. Using 4-wire cord, plug one end into the CTRLR jack on the back of the SPIRIT Attendant ConnecT/R and connect the other end into the STATION jack on the controller.

2.Connect the SPIRIT Attendant to the SPIRIT Attendant ConnecT/R. Using the line cord provided with the SPIRIT Atten- dant, plug one end into the LINE jack (or its equivalent) on the back of the SPIRIT Attendant and connect the other end to the TEL DEVICE jack on the SPIRIT Attendant ConnecT/R.

3.Do not connect a SPIRIT Telephone to the SPIRIT Attendant ConnecT/R.

4.Connect the SPIRIT Attendant ConnecT/R to the AC power outlet. Plug the power connector into the POWER jack on the back

of the SPIRIT Attendant ConnecT/R. To prevent the power cord from pulling out easily, make a small loop of cord near the power connector and slip it behind the strain relief tab next to the POWER jack on the SPIRIT Attendant ConnecT/R. Plug the wall transformer into an AC power outlet that is at least 3 feet away from the controller and not controlled by a wall switch. (If it is any closer to the controller, you may hear a hum on your SPIRIT System.)